  +86-577-66811193       sales@urbanpackline.com
Home / News / Blog / Operation Guide of Automatic Blister Packaging Machine

Operation Guide of Automatic Blister Packaging Machine

Views:324     Author:Site Editor     Publish Time: 2021-06-16      Origin:Site


Automatic blister packaging machine is a kind of medicine packaging machine that many pharmaceutical enterprises will choose. Many enterprises do not know how to use the automatic capsule filling machine after purchasing. The following content introduces the use guide of bubble packaging machine. 

 

1. Turn on the main power switch of the small automatic capsule filling machine, and then turn on the compressed air switch and cooling water switch. 

 

2. Turn on the heating switch of the hand operated capsule filling machine, and the heating function of the machine will be started. 

 

3. Check whether the product batch number of capsule filling machine amazon is correct. If the machine is used to produce military supplies, the batch number of the machine needs to be changed.

 

4. When the heating temperature of the gel capsule filling machine reaches the set value, press the "Jog" key to open the lower mold.

 

5. Lift up the upper heating plate of the oil capsule filling machine, open the "Step Clamp" button, pass the PVC through the molding mold and clamping cylinder, and pass the PVC outside the machine. 

 

6. Close the upper heating plate and press the "Start" button. Then adjust the running speed of the dosator capsule filling machine and make the main engine run at low speed. After the molding, the PVC goes out about 3 meters, and press the "Exact Stop" button to stop the 400 holes capsule filling machine.

 

7. Observe the shape of the blisters to confirm whether they are uniform or rigid, and whether they bend more than 3 meters.

 

8. Cut both ends of PVC with scissors, turn it 180 degrees, insert PVC into the platform, cover the active roller, and press PVC with pressure roller.

 

9. Press the "Start" button to make the semi automatic encapsulation machine run, and then make the PVC go out 1.5 meters, press the "Exact Stop" button to stop the blister packer.

 

10. Pass the PVC through the typing device, before punching, lift up the stepping platen, and pierce the PVC into the punching device. Note that the stepping platen should be placed between the two bubble plates before stamping.

 

11. Before stamping, press down the pressing plate first, then press the "Start" button to observe the typing and stamping position.

 

12. Pass the aluminum foil through the hot pressing roller, turn on the "Heat Seal" button, and press the "Start" button to observe the sealing effect.

 

13. Press the "Exact Stop" button to stop the machine, add material to the main hopper, and turn on the "Load" knob to make the loader work. 

 

14. Press the "Start" button to start the normal operation of the machine. In the production process, you can slowly improve the running speed of the machine. Pay attention to the quality of molding, sealing and feeding at any time. When the speed increasing is large, the heating temperature and forming sealing pressure should be increased properly. 

 

According to the product structure diagram, regularly lubricate the transmission chain, guide pillar, guide bushing and bearing, otherwise the service life of the machine will be greatly reduced.


GET IN TOUCH

Products

About Us

Service

Page

Tel: +86-577-66811193
Fax: +86-577-66812293
No.371 The First Development Road, Economy Development Zone, Ruian City, Zhejiang Province, China
Copyright © 2021 Wenzhou Urban Machinery Co.,Ltd All Rights Reserved.