Fully Automatic Capsule Filling Machine For Powder

Machine introduction

It adopts the disc valve feeding method and is equipped with a vibration device. It solves the problem that the traditional screw feeding device has no fluidity and often fails to feed powders with poor fluidity such as Chinese herbal medicines and proprietary Chinese medicines. Easy to disassemble, easy to replace and clean.

Driven by guide rail, it has high precision and long service life. The closed design effectively prevents waste capsules and dust from entering. Good stability, orderly seeding, and accurate direction adjustment.

One-piece processing and molding, compact structure and no splicing gap, with good sealing and easy disassembly; the upper and lower modules move independently, and the shaft seal of the fixed bracket adopts a double-lip skeleton dust-proof ring, which achieves no noise, small size, and low load. Small and high precision. The interior of the fully enclosed rotary table is free of maintenance, oil, maintenance and powder for three years. Patent No.: (ZL 2015 2 1021530.0)

Modular design is adopted, and the pin-type positioning of the filling holder is used. During production, there is no need to stop the machine to adjust the filling capacity, and it is convenient to replace different filling rods. (Patent No.: ZL 2015 2 1021519.4)

The filling base adopts a negative pressure design, which can suck the powder in the hole of the base through negative pressure when the equipment is running, and recycle it into the powder collector. Effectively avoid the waste and loss of the powder, and realize the secondary use of the powder.

The new-type finished capsule discharge mechanism exclusively adopts the capsule plate design, no external air source is required when the finished capsules are discharged, and there is no dust flying during the production process. , strong permanent usability, less wear and tear.

The slot-type lock capsule plate has flexible adjustability and can be fine-tuned at any time without adjusting the station pull rod.

A soft sealing column is installed on the original suction seat, and the balance between the lower mold and the suction seat is automatically adjusted by the soft sealing column during the production process to prevent vacuum leakage and increase the rate of capsule separation.

Purified compressed air and intermittent gas impingement technology are adopted. It solves the problem of powder sticking to the mold and improves the probability of capsule loading.

Adopt the latest cam bottom transmission system, the transmission bracket runs through the top and bottom of the design, all the running cams use inner groove cams instead of honest outer cams, and the high-speed operation achieves precision, accuracy, stability and no noise.

Negative pressure technology is adopted, and the medicine powder independent shunt system is used to shunt and recycle a small amount of leaked medicine powder in the filling base and the medicine powder in the integrated medicine powder inhaler during the production process, so as to ensure that the medicine powder will not cause cross-contamination with the recycled waste capsules. The powder can be directly re-entered into the machine for production without disinfection.